Consumer unit replacement or extension
The consumer unit is the heart of your installation. We replace and extend consumer units and distribution boards — and prepare them for what's still to come.
- Extra circuits, cooking circuits and power circuits
- Correct residual-current protection
- Preparation for a charge point, home battery and three-phase power
When is replacement wise?
Reasons include: insufficient or missing residual-current protection, a full board, outdated components, recurring faults or an expansion of the installation. A renovation is also a logical moment.
Extending where possible
If the existing board is in good condition, an extension with extra circuits or an additional board is often enough. This is less invasive and cheaper. We first look at what's already there and advise afterwards.
Preparing for charging and storage
A charge point and a home battery each require their own protected circuit, and the cabling must match the power involved. By getting this right in one go, you avoid the board needing to be redone again within a year.
Tidy work, safe completion
We wire the board neatly, label circuits clearly and test the installation before handover. Afterwards you know exactly what's located where.
From request to handover in four steps
- 1
Request
Tell us what you need via the quote form, phone or email. Photos of your distribution board or the intended location help us get started.
- 2
Survey and advice
We assess your situation and installation, on site where needed, and advise what fits technically.
- 3
Quote and approval
You receive a clear quote describing the work. Once you approve it, we schedule the installation.
- 4
Installation and handover
We install, test and commission the system, then walk you through the result.
Frequently asked questions
Want your consumer unit assessed?
Include a photo of your current consumer unit with your request. Often we can then already indicate whether an extension is sufficient.